Products
LEO LGP30-A-1(GX160)
LGP30-A-1(GX160) clean-water petrol pump with GX160 engine, published power 5 HP. Confirm exact supplied configuration, duty and availability.
LEO LGP30-A-1(GX160) clean-water petrol pump
Portable clean-water supply, drainage and irrigation. This page covers the exact A-1 engine variant identified above, not the older A, C, high-head or sewage model. The manufacturer photograph represents the A-1 family; engine, frame and port configuration vary by model.
Model specifications
| Engine designation | GX160 |
|---|---|
| Engine type | Single-cylinder, four-stroke, air-cooled |
| Manufacturer-published engine power | 5 HP; confirm supplied engine rating/nameplate |
| Rated engine speed | 3600 rpm |
| Displacement | 163 cm³ |
| Fuel tank capacity | 2.8 L |
| Engine oil capacity | 0.58 L |
| Inlet / outlet | 3″ / 3″ |
| Liquid | Clean water, 0–40 °C |
| Maximum suction lift | 8 m, subject to installation conditions |
| Manufacturer suction reference | 5 m suction in 120 s under source test conditions |
| Impeller and diffuser | Cast iron |
| Mechanical seal | Carbon / ceramic |
| Pump body | Aluminium |
Follow the supplied engine and pump manuals for fuel, lubrication, priming and installation. Confirm the required flow and head before selection. Do not substitute specifications between engine options.
LGP30-A-1(GX160) individual hydraulic curve and dimensional drawing
Published hydraulic points
| Flow Q (m³/h) | Head H (m) |
|---|---|
| 0 | 30 |
| 5 | 29 |
| 10 | 27.5 |
| 15 | 26 |
| 20 | 24 |
| 25 | 21.7 |
| 30 | 19.5 |
| 35 | 16.9 |
| 40 | 14.4 |
| 45 | 11.6 |
| 50 | 9.2 |
| 55 | 6.4 |
| 60 | 3.5 |
Dots reproduce the published technical table. Straight lines join the listed points only; no extra duty points or zero-head endpoint have been assumed. The final listed flow is not a stated maximum flow.
Model dimensions
| DN1 / DN2 | 3″ / 3″ |
|---|---|
| L | 530 mm |
| W | 420 mm |
| H | 425 mm |
| H1 | 183 mm |
L1 appears on the manufacturer outline but no numerical L1 is provided in this model’s dimensional table. Confirm the supplied installation and clearances before fabrication.